Mechatronics Engineer and 3D Printing Enthusiast
One of the pop-up headlights was not deploying or retracting due to fried logic in the RTR Control Unit (a proprietary Toyota chip). Temporary manual control was achieved (by the use of a bypass momentary switch). A programmable ATtiny microcontroller is proposed as a permanent fix.
See full project
This is a quick tool I whiped up in cad. I was trying to repair the seatbelt winding springs on the Celica when one got unwound. I tried to wind it by hand and was rewarder with cuts on my hands and no srping. I have been trying to wind it manualy for half an hour. With this tool I was able to do it in 5min without feeling I am defusing a timed bomb.
See full project
I solder PCBs regularly. Every time I try to use flux, it's awkward. I push the syringe to get a certain amount, but it keeps feeding flux even after I stop pressing, wasting product and making a mess. I am also cheap and don't like the liquid flux option. Therefore, I designed this mechanical dispenser.
See full project
I was cleaning out my girlfriends room and found an old Korg SAS-20 vintage synth. It belonged to her father. It had great sentimental value to him as it was a gift from an ex relationship he had. He wanted to restore it and learn to play but he never got around to it. He was a very busy and I was looking up to him. He was a genius. He used to have a company and design and build cellphones for rich bussinessmen before mobile phones were a thing in Greece. Enough about the backstory though, lets get to the project.
See full project
